LB Gear pump for freezer

LB type refrigerator gear pump is used for conveying viscosity at 200 ° E (below 1500 mpa. S) not containing solid particles and impurities machine oil, turbine oil and other media have similar lubrication performance and property, the temperature is not higher than 120 °.

Both ends can be used as transfer and pressure pump during transmission.

In the fuel system can be used as transport, pressure, jet fuel pump.

It can be used for lubricating oil pump in all industrial fields.

Scope for conveying not containing solid particles and fibers, non-corrosive, applicable temperature is 10 ℃ ~ 80 ℃, the viscosity of 5 ~ 1500 st lubricating oil or other liquid properties similar to lubricating oil.

The gear adopts a new technology with the advanced level of the international eighties.

It is compared with the involute gear, the most prominent advantage is in the process of the gear and tooth profile surface no relative sliding, the tooth surfaces without wear, balanced operation, no trapped fluid phenomenon, low noise, long life and high efficiency.

The gear oil pump is free from the constraints of traditional design, which makes the gear pump enter a new field in design and production.

The pump is provided with differential pressure relief valve as overload protection, and the full return pressure of the safety valve is 1.5 times of the rated discharge pressure of the pump.

It can also be adjusted according to actual needs within the allowable discharge pressure range.

However, within the allowable discharge pressure range, it will be adjusted according to actual needs.

However, the relief valve cannot be operated for a long time and may be installed separately on the pipe line if necessary.

Features a pair of arc sine curve gear with the advanced technology of the international eighties.

It is compared with the involute gear, the most prominent advantage is in the process of the gear and tooth profile surface no relative sliding, the tooth surfaces without wear, balanced operation, no trapped fluid phenomenon, low noise, long life and high efficiency.

This pump is free from the bondage of traditional design, which makes gear pump enter a new field in design and production.

The pump is provided with differential pressure relief valve as overload protection, and the full return pressure of the safety valve is 1.5 times of the rated discharge pressure of the pump.

It can also be adjusted according to actual needs within the allowable discharge pressure range.

However, within the allowable discharge pressure range, it will be adjusted according to actual needs.

However, the relief valve cannot be operated for a long time and may be installed separately on the pipe line if necessary.

The pump shaft end bee is designed in two forms, one is mechanical seal, the other is packing seal, can be determined according to the specific use situation and user requirements.